For more details, refer Procedure 6, Test Condition K, Page no of Defence. Standard JSS Rev Low Temperature Test. 3 days ago , Document No. Nomenclature, Standardisation Sub-Committee. , (Third Revision), COMPOSITION FLARES, BEACON. recommended as per JSS, Military standard, Class L2H category, and functional specifications and no damages should be seen as an outcome of.

Author: Garr Gardajin
Country: Montserrat
Language: English (Spanish)
Genre: Medical
Published (Last): 18 March 2011
Pages: 266
PDF File Size: 5.42 Mb
ePub File Size: 6.8 Mb
ISBN: 373-6-56219-807-6
Downloads: 38743
Price: Free* [*Free Regsitration Required]
Uploader: Taulkree

In some of the tests, the test conditions are varied in order to enable the designers to select the conditions which will be adequate to meet the users qualitative requirements, commensurate with the design efforts.

This site is temporarily unavailable

This calls for the relevant equipment specification, which is a governing document for production and supply of the equipment for the users and shall always invoke the tests and conditions laid down in this specification, to provide a common basis for comparison for performance of various electronic and electrical equipment under Service environments.

If spcifications damage has occurred document it with the trucking company immediately. Exposure procedure for artificial weathering.

Ground equipment partially spexifications h L2G: To be used in position shielded from the weather ashore and afloat. Shipborne equipment submersible unpacked: Safety This Safety Guide contains More information.


For this purpose, the volume of the test chamber should preferably be not less than eight times the volume of the equipment under test. Patented circuits give outstanding range. Shipborne equipment protected unpacked b N2: Fleet air arm flight deck test equipment unpacked b NA2: National Electrical Manufacturers Association More information.


Installed in tracked vehicles: DecemberJuneDecemberMarch Liquid-in-glass thermometers selection, use and calibration Copyright National. Ground equipment partially protected c L2B: Affordable, sturdy, reliable Portable, battery-powered. The tests described herein are not to be interpreted as an exact and conclusive representation of actual operational and storage conditions. During the visual examination of the equipment, defects in construction, the presence of foreign bodies, moisture, dust, etc.

Accordingly, a relatively small number of sets of conditions of use have been selected and classified as described in Clause 2 below.

JSS 55555 – Antifungal Test – Electronics

II, shocks as per face 24 Note: Transmission line insulator condition monitoring is of increasing interest with the ageing of many transmission. Date Amendment pertains to: Liquid-in-glass thermometers selection, use and calibration Technical Note 19 March Issued: Weather is a result of the atmosphere s constant attempt to reach equilibrium.

After a helical groove has been cut in the resistive.

Staff Engineer September 25, Moisture can be a problem. Classification of groups of environmental. Contact your Kellogg Distributor.

This equilibrium is continually upset More information.

Distribution Lines Technical specifications of composite type spacers for L. Ground equipment exposed and immersible unpacked: In addition Test No. Quite often, equipment may have a dual use in such speckfications, tests for more than one class may be required.


Page 1 of 5 Rev: Therefore, the speciflcations equipment specification should choose only those tests out of each table which are considered essential with clearly specifying the severity limits for the equipment under test.

Ground equipment partially protected l L3: Once-through cooling needs large natural bodies of water. Corrosion acid see Note 1, 2 and 3 Corrosion alkaline see Note 1,2 and 8 3 RTD s are not commonly used above 9 F.

Such instructions, together with the incidence and grouping of Equipment for tests for the purposes of design approval and the acceptance inspection shall be specified in the relevant equipment specification.

It is also the purpose of this document to standardize environmental tests in order to obtain, as much as possible, reproducible test jsss.

No requirement for relative humidity is given because its correction by calculation is generally not possible. To be used in the field or in a vehicle where it is fully exposed to the weather during storage and use and liable to immersion in water.